Hi,
I would like to get the ir codes from the irtrans device (network) without the optional db or learning process.
Now when I connect to the device and send ASCR or ASCI I can get responds on things like Aver.
When I take a remote and point it at the device and push a button the device does not automaticly send the code for this button.
The manual says that code not in the db are not being sent out to me, therefor without a db I can wait very long.
I have tried in UDP and TCP mode and this makes no difference.
It seems to me this is possible because the irtransserver would need this function to work.
I'm guessing I have to send a command to tell the irtrans device to start sending me it's data.
Also I'm unsure, should I use TCP or UDP and should I start with ASCR or ASCI.
I looked at the source to find the answer but I'm no C programmer and I can't find it.
It is important to me to use the device without the supplied software because I use FreeBSD my "server" needs to translate the ir codes in other commands for other ethernet devices.
Kind regards