irtrans and vera3

IRTrans Software plugins for applications like Girder, Homeseer and many more

Moderator: marcus

irtrans and vera3

Postby musca » Tue 27. May 2014, 09:46

Hi,
I've been using irtrans lan i/o for 3 years already with homeseer and I can tell that is one of the most stable and reliable IR device I ever seen.
Now I am building 3 new houses and I need to make 3 new automation systems. The difference is that it will be based on Vera3 (micasaverde). I have checked for a plugin for irtrans to make it work with Vera but . . . .nothing.
What I basically need is a plugin to install the IRtrans as a Ir transmitter.
Does this plugin exists?
If not, how complicated would be for me to try to write one? What programming language?
Thanks,
musca
 
Posts: 14
Joined: Fri 18. Feb 2011, 23:39

Re: irtrans and vera3

Postby eric » Tue 27. May 2014, 12:16

I'm not familiar with this device (Vera3) and I am almost sure there is no plugin for IRTrans.

However - if you can get the Vera homecontroller to send simple ASCII Strings to an IP adress via UDP or make a http request you don't need a plugin to send IR.
Most homecontrollers can be configured to do that when an event is triggered. For example all the Vera controller has to do is open a link similar to this:
Code: Select all
http://<ip_of_irtrans>/send.htm?remote=<remote_name>&command=<command_name>
eric
Administrator
 
Posts: 157
Joined: Mon 22. Oct 2012, 10:05

Re: irtrans and vera3

Postby musca » Tue 27. May 2014, 16:25

I already did that. I was able to sent a http request and it worked. But this will imply to create an event for every ir command. Taking into account that I have 10+ remote controls and each of them with 10+ commands this means 100+ events only for Ir.
The easiest/normal way to do it in Vera would be to have the irtrans installed with a plugin. Then I can automatically create remote controls with Vera and I can select from a drop-down list the IRtrans as an IR transmitter.
Vera uses the Lua programming language for writing scripts.
If I would start writing a plugin myself, what command should I use in Lua to communicate with the irtrans?
musca
 
Posts: 14
Joined: Fri 18. Feb 2011, 23:39

Re: irtrans and vera3

Postby eric » Wed 28. May 2014, 09:08

in this case I suggest using the ASCII API. Your plugin communicates with the IRTrans via simple ASCII strings.
The appropriate programming manual is available in the downloads section of our website.
eric
Administrator
 
Posts: 157
Joined: Mon 22. Oct 2012, 10:05

Re: irtrans and vera3

Postby musca » Wed 28. May 2014, 23:25

Thank you Eric. Appreciate your help.
Regards,
Andrei
musca
 
Posts: 14
Joined: Fri 18. Feb 2011, 23:39


Return to Plugins

Who is online

Users browsing this forum: No registered users and 2 guests

cron