IRTrans Support Forum

HI

I am using 2 modules 1) Ethernet module and unit 0 2) Wifi module unit 1

I am also using the Homeseer plugin. I have sucessfully set up both modules and am able to send IR codes to the individual modules.

I am now trying to set up events based on IR codes received by the modules. The ethernet module receives the IR signal correctly, but when I send an IR signal in front of the wifi module my the module receives the signal but the log says it is on unit 16???, I cannot set my computer fire an event on this received signal since I do not have a unit 16.


here is the pertinent part of the log:

28/07 06:43:21.5720000 : STATUS 0 : IRReceived method called: unit 0, remote hs2_signals, command 2
28/07 06:43:21.5780000 : STATUS 0 : IRReceived method called: unit 16, remote hs2_signals, command 2

any help is much appreciated.

Hi,
that is obviously a problem with the Homeseer plugin.

That plugin was not made by us, however there is a Homeseer support forum that also covers the IRTrans plugin.

IRTrans