Page 1 of 1
CCF converted codes do not work
Posted:
Mon 5. Jul 2010, 15:17
by trinidex
IRServer Version 5.11.08
[ 0]: IRTrans LAN: IR VER: E5.11.10
ETH VER: L1.06.26
Used CCF Extractor to convert a CCF file - process worked perfectly, saved to irTrans okay.
Rebuild database - OK
Send Command - remote and commands are shown.
Sending commands fail - no response for irTrans unit (no LED blink) and device does not respond.
Thanks for assistance.
Re: CCF converted codes do not work
Posted:
Mon 5. Jul 2010, 15:21
by IRTrans
Hi,
no idea what the problem is. We would need to see the .rem file to tell you more.
Maybe these are CCF codes for a different Pronto remote using a different format.
IRTrans
Re: CCF converted codes do not work
Posted:
Mon 5. Jul 2010, 15:30
by trinidex
Thank you
I have attached the .rem file
- dish.rem
- Converted CCF file
- (2.09 KiB) Downloaded 2592 times
Re: CCF converted codes do not work
Posted:
Mon 5. Jul 2010, 17:35
by IRTrans
Hi,
that is not a standard Pronto CCF Format that is supported by the IRTrans.
The IRTrans SW supports the original Pronto CCF/Hex Format used by the Standard Pronto remotes.
The normal Pronto codes never have "0000" in the first 4 blocks of the code. Only the first block should be "0000". You might try to remove the first 3 blocks.
It does look like a 56kHz code though.
IRTrans
Re: CCF converted codes do not work
Posted:
Tue 6. Jul 2010, 01:45
by trinidex
Thank you I will try your suggestion and different codes.
Re: CCF converted codes do not work
Posted:
Tue 6. Jul 2010, 13:49
by trinidex
I have new codes (attached) but they do not work consistently.
Are the codes valid or is there something else I'm missing?
Thanks
- dish.rem
- Dish Network codes
- (1.48 KiB) Downloaded 2489 times
Re: CCF converted codes do not work
Posted:
Tue 6. Jul 2010, 13:52
by IRTrans
No idea what to do. Without having the remote control there is no way for us to test or verify those codes.
IRTrans
Re: CCF converted codes do not work
Posted:
Thu 8. Jul 2010, 00:15
by trinidex
It looks like the ‘LAN Controller XL’ CCF implementation is to blame here.
I have used the same CCF codes with a Crestron ST-CP and the codes work.
As a workaround I have resorted to connecting the ‘LAN Controller XL’ to the Crestron ST-CP using RS232, this way I send RS232 commands from the ‘LAN Controller XL’ to the Crestron ST-CP which sends the IR signals.
Not an ideal solution but I have achieved what I need.
Re: CCF converted codes do not work
Posted:
Fri 9. Jul 2010, 09:36
by IRTrans
Well, the problem is that you are using a CCF version that is not supported by our SW.
IRTrans