I am trying to change the IP address of an IRTANS LAN Controller XL using the following procedure
I using the default address 192.168.0.32 (web interface)
Enter the login userid and password
Click on IP Settings
Uncheck the Use DHCP
Uncheck the option to use 192.18.0.32 when no DHCP is available
Click save setting
I get the red message that it is saved
Enter the new IP address, mask and gateway
Click save setting again
I get the red message that it is saved
Click Reboot System
Then I can’t ping or access the controller using the new address, I tired address in the same range of the default IP address with the same result. I connected the PC and the controller on another switch with nothing else, again the same results. I tried using DHCP server, but the controller would not get an address from it, I tried the IP assign utility but it can’t find the controller or the other IRTRANS devices on the network even though I can ping them. I can only access it again when I reset the device to the factory default using the jumpers using 192.168.0.32
I have followed the same steps with the other IRTRANS devices and it worked perfectly.
Thanks for your help