While installing an additional IRTrans module I used iRedTouch "Identify Module" to help with debugging/installation.
On my new one the LED just flashed very briefly. When I tried it on an older POE module, one that has been working ever so nicely, the LED flashed for a long time and ever since it seems to be locked into repeating mode. I have input configured OFF but it's not anymore.
I have re-configured, rebooted, disconnected for a while but it is receiving and repeating all IR commands sent by a regular remote.
Is there any way to force a factory reset perhaps?
In the configuration I have IR Send checked and Internal and External LED's checked. Rest all unchecked.
Have also tried it with only External LED active checked. It still repeats my regular remote IR.
Command sent via iRed2 also repeat so it's not just repeating IR received. I'm totally confused, hence the hope that a factory reset exists.
Edit: Found the reset instruction posted las year. Will wait to see if there are other suggestions though as I figure it's not a task to attempt late in the day
Edit-2: The reset did the trick to return the module to normal. However, it was set to DHCP but did not pick up an address even when a static IP was defined to the ethernet address of the module.