using bus module

[Fischer]

hi,

i have an usb module and a bus module connected with 3Wire sbus.
I want to send an ir command to bus module.
On bus module, dip switch "2" is set (down) , switch "1" 3" and "4 "are reset (up) : adress in binary is 0010 : 0x02 in hex.

Communication seems to be ok (using urtrans client, i see both device at @ 0 and 2.

Now i try to use irtrans client to send command. i tried all "device id" values : "alle", 0 -> 15.
On usb module it is working.
On bus module it does not work. !!!
All parameters have the default values, i do not change these values.
regards

[IRTrans]

Hmm, that is strange, Device ID 2 should send via the Bus module.

Please check what the LED of the Bus module shows when you try to send an IR Code.

IRTrans

[Fischer]

The ir led flashes only at power up.

When i send commad to bus module the LED does not flash.
When i send commad to usb module the LED it is ok.

I have 4 bus modules with the same issue.

I think where is something wrong in wiring or configuration.

Hard copy joined => to check

regards

[IRTrans]

I know what the problem is:

You first need to enable the option "SBUS Send" on the IR Bus Tab in the Device Settings (GUI Client) of the USB Module.
Sorry that I did not remeber that at first ...

Your cabeling is surely OK - otherwise the device status would not work.

IRTrans

[Fischer]

I m using gui client v 6.1.10,
no such option "sbus send":
attached a screenshot :



regards.

[IRTrans]

Then you will need to download the current SW from our website.

IRTrans

[Fischer]

New SW downloaded.
it works, great.

What append with my old usb module : FM U6.00.05 ?

Can you send new fw : U6.04.40 ?

So i will be able do made a clean configuration.

Regards

[IRTrans]

Please send us an Email, then we can send you a firmware update.

IRTrans