hi,
i have an usb module and a bus module connected with 3Wire sbus.
I want to send an ir command to bus module.
On bus module, dip switch "2" is set (down) , switch "1" 3" and "4 "are reset (up) : adress in binary is 0010 : 0x02 in hex.
Communication seems to be ok (using urtrans client, i see both device at @ 0 and 2.
Now i try to use irtrans client to send command. i tried all "device id" values : "alle", 0 -> 15.
On usb module it is working.
On bus module it does not work. !!!
All parameters have the default values, i do not change these values.
regards