What does the "S" do? This is not documented in the user manual.
If I have 5 different timing pairs defined, then how do I translate them for the actual command?
If I need to use timing 1, then do I use 0 in the command syntax? For example, would the following be correct?
- Code: Select all
[TIMING]
[0][N]5[1]640 1304[2]1616 900[3]640 670[4]640 9300[5]1616 9620[RC]7[RP]0[FREQ]455
[COMMANDS]
[TEST0][T]0[D]222222222223110010101101011011111111111010100111111001101104