IRTrans Support Forum

To be honest - I do not know. However, we cannot support "selfmade" RAW IR Codes - I only know that the codes that our devices learn are sent correctly again.

Analyzing that RAW Codes is very time consuming and simply beyond that what we can do with our support.

IRTrans

OK, can you then just tell me is there any other rule that I should comply with for IRTrans RAW codes except:

- all pulses/gaps must be multiplies of 8

- gaps/pulses larger than 2048us must be written in this form eg. "0 8 536".

Thank you for the answer!

In general those are the rules. However, the code length does also matter - if it is wrong there might be problems, too.

IRTrans

Thank you for the info.

What did you mean with the "code length does also matter". Did you mean that I should be careful that this number "[RAW]87" corresponds to the actual number of pulses and pauses or something else?

Correct - the number has to equal to the number of values that follow.

As the last pause is never sent (that would make no sense) the number is always non-even.

If there is a 0 sequence (e.g. 0 8 320) it counts a 3 bytes.

IRTrans