IRTrans Support Forum

Hi,

I installed irTrans software for irTrans ethernet device. I powered the irTrans hardware device and connected the ethernet cable. I was able to start the irServer after assigning an IP address to it. I then started the GUI Client. However I am not able to send any commands nor learn any command using the IR Trans GUI Client. I get an error message "IR Error: Could not bind to IP socket(Another server running??)" everytime i click on Device status or send command on the GUI client.

Please help me fix this issue

Note: I was able to detect the IR commands that I sent using a Remote on irServer.

Regards,
Suraj

What programm is giving you this error message ?

Either you messed up the starting order of the software or you have some sort of problem with the IP configuration on your PC.

IRTrans